These sleeves are for the Canik TP9 Elite SC only! They will not work with other Canik models.
These are not extensions that add to the magazine capacity.
These magazine sleeves are designed to ergonomically extend the grip down when longer mags used with the Canik TP9 Elite SC. These will help eliminate the weird "short" feeling in your hand when using the factory supplied sleeve for the 15 round, and make the Promag 18 round magazine feel like it was factory designed for the Elite SC.
The Canik TP9 Elite SC 15 round magazine is designed to fit Canik magazine part number MA903 with the factory baseplate. This magazine and both baseplates came with the Canik TP9 Elite SC form factory. It will also fit Canik magazine part number MA595. Both these magazines are very hard to find right now.
The Promag Canik TP9 18 round magazine is designed to fit Promag part number CAN-A1. These magazines are readily available from quite a few internet shops if you can’t find one local to yourself.
The sleeves are designed for the factory backstraps. Aftermarket backstraps may pair up ok, or they may not. I unfortunately can’t test them all.
These are 3D printed in PETG, a very durable and temperature stable plastic. They are also printed with a “fuzzy” texture that helps hide the 3D printed layers and gives your hand and fingers something to grab on to instead of slick plastic. I have tested these with numerous mag drops while at the range with no damage to the sleeve. They will fit snugly on your magazine and shouldn’t fall off under normal use.
Magazines, firearms, or hands ARE NOT INCLUDED and are only pictured for informational purposes only.