These sleeves will work with any Canik TP9 series pistol EXCEPT THE ELITE SC!
If you have the Elite SC, Elite CAS, Sub Elite, or Sub Mete, you want these sleeves.
These are not extensions that add to the magazine capacity.
The slick side option will not fit if you decide to install the factory magwell. Magwell options will work if you remove the magwell, but there will be a 1/8 inch / 3mm gap between the sleeve and grip when the magazine is inserted.
These magazine sleeves are designed to ergonomically extend the grip down when longer mags used with the Canik TP9 pistols. These will help eliminate the gap between pistol and the mag base plate when using 18 round magazines.
The Canik TP9 18 magazine is designed to fit Canik magazine part number MA548 with the factory baseplate.
The Promag 18 magazine sleeve is designed to fit Promag part number CAN-A1. These magazines are readily available from quite a few internet shops if you can’t find one local to yourself.
The sleeves are designed for the factory backstraps. Aftermarket backstraps may pair up ok, or they may not. I unfortunately can’t test them all. If you have questions about whether they will fit, send me a message and I’ll take a look for you.
These are 3D printed in PETG, a very durable and temperature stable plastic. They are also printed with a “fuzzy” texture that helps hide the 3D printed layers and gives your hand and fingers something to grab on to instead of slick plastic. I have tested these with numerous mag drops while at the range with no damage to the sleeve. They will fit snugly on your magazine and shouldn’t fall off under normal use.
Magazines, firearms, or hands ARE NOT INCLUDED and are only pictured for informational purposes only.